Paver Base Depth in Connecticut: What Frost Actually Requires
Base depth is where patios are won or lost in this state. Connecticut ground freezes and heaves every winter, and the base, not the paver, is what decides whether your surface is still flat in five years.
The depths that hold up here
| Surface | Compacted base | Plus bedding | Total dig (with paver) |
|---|---|---|---|
| Patio / walkway (foot traffic), firm to average soil | 5-6" | 1" sand | 8-9" |
| Patio or walkway on soft or wet soil | 7-8" | 1" sand | 10-11" |
| Driveway / anything vehicles touch | 8-12" | 1" sand | 12-16" |
Why Connecticut is stricter than the bag instructions
- Frost heave is the enemy. Water in the soil freezes, expands, and lifts whatever sits on it. A properly compacted gravel base drains and moves as one plane instead of one paver at a time.
- Our soils vary street to street. Sandy, well-draining ground gets away with the minimum. Clay-heavy or low, wet ground needs the deeper section, that's the soil question the calculator asks before it sizes your base.
- Compaction happens in lifts. Gravel gets placed and compacted 2-3 inches at a time. Eight inches dumped and plate-tamped once is not eight inches of base, it's a future dip.
The ordering math
Gravel is ordered loose and ends up compacted, so two numbers matter. Area in square feet times depth in feet, divided by 27, gives compacted cubic yards. Multiply by 1.2 for the loose volume the truck carries, then by 1.6 tons per loose cubic yard. A 12 by 20 walkway at 4 inches is about 3 compacted cubic yards, about 3.6 loose, and about 5.7 tons on the truck. The calculator runs this for your exact shape and adds the base that extends 6 inches past the paver edge, then adds the spoil volume so you know what is leaving the site, not just what is arriving.
Where these numbers come from
Base thickness ranges follow the Concrete Masonry and Hardscapes Association (CMHA, formerly ICPI) Tech Spec 2 for interlocking concrete pavement on a compacted aggregate base, adjusted upward for Connecticut frost and soft soils the way local masons build. Paver units are specified to ASTM C936 (manufacturer catalogs state compliance). Base aggregate is dense-graded processed gravel per ASTM D2940 or the CT DOT equivalent. Density and compaction figures are the yard values the calculator engine uses, so the guide and the calculator agree.